Group Numbers Describe an Envelope, Not a Performance Grade
An H6 or LN3 designation describes a physical envelope: length, width, overall height and terminal layout. It says nothing about capacity, cranking current or chemistry. That is why two batteries carrying the same group number can be electrically different products, and why a fitment list built only on group codes will still generate returns. Build your matrix on the envelope dimensions first, then record the electrical specification separately, so a customer asking for an H7 replacement can be matched on both.
Terminal Polarity and Hold-Down Errors That Cause Returns
The most common avoidable return is reversed terminal polarity, which cannot be corrected by the customer because the positive cable will not reach. Record the positive terminal position (left or right) for every SKU you stock, and put it on the carton, not only in the catalogue. The second most common is the hold-down ledge: some vehicles clamp on a bottom ledge, others use a top frame, and a battery with the wrong ledge height will sit loose or refuse to seat. Ask your supplier for a dimensioned drawing with both ledge positions marked before you approve tooling.
Height, Cabling and Venting Checks
Overall height matters more on modern vehicles than it did on older platforms, because seat frames, bonnet liners and battery covers sit close to the terminal posts. On a lithium replacement, the terminal posts are often shorter than the lead-acid original, so check that the original clamp still bites. Venting is the reverse concern: a sealed LiFePO4 pack does not need the vent tube the flooded battery used, but the vehicle may still route one, and the customer will ask. Prepare a short fitment note explaining that the vent is no longer required and that the battery is sealed.
Building a Fitment Matrix for Your Market
Start from the top twenty vehicles in your territory by registration volume. For each, record group size, terminal polarity, hold-down type, overall height and the original capacity. Cross-reference against your supplier catalogue and mark the gaps. That table becomes your purchasing brief, your returns-reduction tool and your sales collateral at the same time, and it is the single most useful document a start-stop distributor can own.
Have a sourcing question?
Share your application or project requirements with the Chude team.
