Watts and watt-hours answer different questions
Watts (W) describe power at a moment in time; watt-hours (Wh) describe energy. A 100 W device running for five hours consumes 500 Wh. A large battery does not automatically provide a powerful inverter: check both the stored energy and the continuous AC output rating. For an importer building a product range, these should be separate columns in the comparison sheet.
Calculate the daily energy requirement
List each device, its measured average power, and its required operating hours. For an illustrative setup, a 60 W laptop used for four hours consumes 240 Wh, a 10 W light used for five hours consumes 50 Wh, and a 40 W fan used for three hours consumes 120 Wh. The total is 410 Wh at the devices. These assumed loads are examples; measure the actual equipment before selecting a model.
Allow for losses without promising a fixed efficiency
A starting estimate is runtime in hours = nominal battery Wh × assumed usable fraction ÷ average load W. At an explicitly assumed 80% usable fraction, a hypothetical 1,000 Wh station supplying 100 W would run for about eight hours. This is planning arithmetic, not a tested CHUDE specification. Inverter idle consumption, temperature, battery condition, output port and shutdown settings all affect the result. Ask for measured output energy at the load level your customers will use.
Check startup demand and cycling loads
A refrigerator or motor may need more power to start than to run. Confirm the required starting power and duration against the inverter specification, then test the actual appliance. Do not divide battery capacity by a refrigerator nameplate rating to promise runtime: compressor duty cycles vary with ambient temperature, thermostat setting and door opening. Record energy over a representative operating period instead.
Create a sample acceptance record
Start with a fully charged sample and record ambient temperature, output mode, connected devices and measured load. Log the start time, delivered energy and time to automatic shutdown. Repeat under the intended use conditions, including any low-load auto-off setting. Agree the acceptance method with the supplier before the purchase order so different samples can be compared fairly.
What to send with an OEM enquiry
Provide the device list, simultaneous load, startup requirements, daily energy demand, target runtime and charging opportunities. Include regional socket and voltage requirements. Ask for the exact model datasheet and a load-specific sample test rather than selecting solely from a headline wattage. For background on the runtime calculation and its limits, see the manufacturer reference linked below.
References & further reading
Have a sourcing question?
Share your application or project requirements with the Chude team.
